Vista, CA NT Table of Contents. Directed electronics owner's guide vehicle security system t 20 pages. Directed electronics owner's guide vehicle security system t 28 pages. Directed electronics state-of-the-art motorcycle security system owner's guide t 25 pages. Directed electronics model t car security system owner's guide 20 pages. Directed electronics combination remote start alarm system owner's manual xv 52 pages. Viper vehicle security system model esp owner's guide 29 pages.
Vista, CA Page 3 This wire supplies - ground as long as the system is armed. This output ceases as soon as the system is disarmed. It can be used to turn on an optional sensor or to control an optional accessory, such as a window module or pager.
Never use this wire to drive anything except a relay or a low-current input! The transistorized output can only provide mA of current, and connecting directly to a solenoid, motor, or other high-current device will cause it to fail. Page 5 Zone 1.
Page 6 Connect this wire to an ignition source. Make sure that this wire cannot be shorted to the chassis at any point.
Alarma auto Hornet 740T
This wire will report Zone 5. Never use this wire to drive anything but a relay or a low-current input! The tran- sistorized output can only supply mA of current.
Connecting directly to a solenoid, motor, or other high-current device will cause it to fail. Remember that the functions of these wires reverse between Type A and Type B!
The fuse used on volt inputs should be 7. To interface, see diagram below. The system must be programmed for 3.
Page 14 When interfacing with this type of door lock system, two relays or a 4 4 5 5 1 1 M M must be used.
Alarme auto hornet 740t manual
Page 15 4. Once the resistor value s is determined, refer to the wiring diagram for proper wiring.
Page 16 4. Page 18 There is a dual-stage impact sensor inside the control unit.
Directed Electronics Hornet 740T Installation Manual
Adjustments are made via the rotary control as indi- cated above. There is a basic sequence to remember whenever programming this unit: Door, Key, Choose, Transmit and Release. For a four-button transmitter, the different channels must be taught to the transmitter individually. Page 24 If this error chirp is not desired, use this feature to disable the door open error chirp.
If the bypass chirp is turned off, no bypass chirp will be generated, even if a door is accidentally left open. When disarming the system, 5 chirps indicate NPC is activated.
The LED will report the zone that has been bypassed.
See Table of Zones section of this guide. Page 26 Are the door inputs connected? This wire must be powered in the run and start positions in order to work properly. Comments to this Manuals Your Name:.
Enter text from picture:. Latest comments:. Print page 1 Print document 29 pages. Cancel Delete.
Directed Electronics 730T Owner's Manual
Sign in OR. Don't have an account? Sign up! Restore password.