Table of Contents. Configuring V. Avaya G Install Book pages. Page 2 Avaya does not guarantee that these links will work all the printing, Avaya assumes no liability for any errors. Avaya reserves the time and has no control over the availability of the linked pages.
Avaya g430 gateway manual for windows
Page 3: Ip Codec Set Avaya. This equipment returns answer supervision signals on caused by unauthorized modifications of this equipment or the all DID calls forwarded back to the PSTN.
Page 5 CO trunk 02GS2 0. Page 6 Documentation, Hosted Service s and Product s should be construed as granting, by implication, estoppel, or otherwise, any license or right in and to the Marks without the express written permission of Avaya or the applicable third party. Avaya Inc. Page 8 Configuring V. Intended audience The information in this book is intended for use by Avaya technicians, provisioning specialists, business partners, and customers.
G430 Media Gateway
To understand the terms of the limited warranty, see the sales agreement or other applicable documentation. In addition, the Page 12 Introduction Configuring V. Page Chapter 2: Requirements - Hardware version 1. Page 14 Requirements Configuring V.
Page 16 MP correctly. About this task You do not need to configure the G when you install an MP However, you must configure V. Page 17 2. Locate the MP module slot.
MP20 or MP80 module slot 4. Push the module in all the way. Do not use too much force. Flatten the module to flush with the main board. The latches at both sides click shut. Lift the cover off the G Figure 5: Removing the G cover screw from the top of the device Configuring V. G left-side cover screw b.
G left-side cover screw c. G left-side cover screw Configuring V. Page Inserting A Voip Module 1. The lower board for the MP has a plastic standoff.
Insert the plastic standoff to MP Note: This step is applicable only for MP installation.
Figure 8: Insert plastic standoff Configuring V. Page 25 5. Flatten the module so it is flush with the main board. Tighten the locking screw affixed to the VoIP module. This secures the VoIP module to the motherboard. Page Chapter 5: Configuring V.
To provide flexibility in the installation sequence, you can configure Communication Manager Gateway features before the hardware is installed in the gateway. Page Ip Codec Set G default setting. To modify the values of the fields on this screen, use the following command: change ip-codec-set n, where n is the IP codec set number. Note: Transporting modem signals over IP between Avaya Communication Manager systems and media gateways is a proprietary implementation.
Avaya G450 Configuration Manual
The selection of the V. For modem transport interoperability with third-party gateways, vmr is the recommended mode of operation. Page Note Turn off special fax handling.
This mode may be coupled with Redundancy.
The default value is kilobits. You can enter a value between 64 kilobits and kilobits, with an increment of 64 kilobits.
Tips for Searching Avaya Support
A typical video endpoint does not require more than kilobits. Page Modem Mode G. The default value is n. Modulation Mode Avaya V. For users who need other modulations, you must set the Modem Mode field to pass-through.
The following fields show whether V. Page 36 The system sets the V. Use this entry to disable the V. Page 37 to The default value is bytes. Note: Maximum SPRT payload sizes might vary across different gateways depending on the firmware and the hardware versions. Page 38 Use this field to set the value of the acknowledgement timer of Transport Channel 2. This field accepts values between 50 and but only in multiples of The default value is Page 40 Configuring V.
Field replaceable units Modem Mode MP modules IP codec set Modem Relay Preferred NoAudio Modulation Mode G cover Page 42 VoIP module This manual is also suitable for: G Comments to this Manuals Your Name:. Enter text from picture:. Latest comments:.
Avaya Gateway Port Mirroring - This Video, G430
Print page 1 Print document 42 pages. Cancel Delete.
Sign in OR. Don't have an account? Sign up! Restore password.