- Cisco 1230AG - Aironet - Wireless Access Point Configuration Manual
- Cisco Aironet 1140 Series Manuals
- CISCO AIRONET 1140 MANUAL PDF
- Cisco AIR-LAP1142N-A-K9 Getting Started Manual
- Cisco Aironet 1240AG Series Hardware Installation Manual
- Cisco Security
- CISCO AIRONET 1140 SERIES ACCESS POINT MANUAL PDF
- Related Manuals for Cisco Aironet 1240AG Series
- Wall or Ceiling Mount for the Cisco Aironet 1140 Series
Cisco 1230AG - Aironet - Wireless Access Point Configuration Manual
Page of 40 Go. Page 8 - Connecting to the Controller Via a Brows Page 24 - Configuring a New Controller Starting fr Table of Contents. Cisco mesh access points, design and deployment guide, release 7.
Cisco series wireless lan controller 50 pages. Integrated wireless lan controller switch 49 pages.
The patent applications held by Polycom, Inc. All customers requiring PTT using these models should pilot test this feature at their deployment site.
The Startup Wizard provides for an easy means to perform initial controller setup and provisioning.
Cisco Aironet 1140 Series Manuals
Make sure that the correct version of software, listed in the Product Summary, is installed on the controller. From the main menu, click Monitor.
Your configuration may differ, and the appropriate adjustments must be made. From the main menu, click Controller. In the navigation pane, click. Verify that the proper IP Interfaces addresses are assigned to the interfaces.
CISCO AIRONET 1140 MANUAL PDF
Under click Interface Name management 4. From the main menu, click Wireless 2. In the navigation pane, under click , then select Access Points Radios. All the APs that are connected should be listed, showing In the navigation pane, under click then select Access Points Radios,. In the navigation pane under , click Set From the main menu, click WLANs 2. Click the button.
Cisco AIR-LAP1142N-A-K9 Getting Started Manual
Apply 5. Select the for the voice SSID. Under the tab, set. This is the Quality of Service Platinum required setting for voice traffic.
Cisco Aironet 1240AG Series Hardware Installation Manual
Set Note: This is required for usage with WPA-Policy ii. At select from the drop-down list. Click the button to save all changes. Controller Setup The initial setup of the controller is shown below.
The setup instructions outlined in this document are for the configuration shown in the diagram only. It is not necessary to configure each AP individually. Repeat this step for the interface.
Click the button and save the changes. In the navigation pane, under click Select from the drop-down list for the access point you Configure wish to change. The radio will be re-enabled Click the Apply button to save the settings. In the navigation pane under select Select from the drop-down list. Click the button to save the settings.
CISCO AIRONET 1140 SERIES ACCESS POINT MANUAL PDF
Apply In the navigation pane under In the navigation pane under click Use the default bytes. Fragmentation Threshold Set the Beacon Period Select the checkbox. This step is optional if Admission Control the handset is configured with Admission Control set to Optional, this setting must match setting in Video Click the button twice.
Under the tab. For WPA2-Enterprise WPA2 Policy ii. Select the check box for WPA2 Encryption iii. At , select from the drop- Auth Key Mgmt This manual is also suitable for: series series series g Show all Comments to this Manuals Your Name:.
Related Manuals for Cisco Aironet 1240AG Series
Enter text from picture:. Latest comments:.
Print page 1 Print document 40 pages. Cancel Delete.
Wall or Ceiling Mount for the Cisco Aironet 1140 Series
Sign in OR. Don't have an account? Sign up!