Delta Miter Saw Manual 36-220

Delta miter saw manual 36-220

Shop by category

This website or its third-party tools use cookies, which are necessary to its functioning and required to achieve the purposes illustrated in the cookie policy. If you want to know more or withdraw your consent to all or some of the cookies, please refer to the cookie policy. By closing this banner, you agree to the use of cookies.

Page of 24 Go.

Delta Miter Saws Owner's Manuals

Table of Contents. For Parts, Service, Warranty or other Assistance,.

Delta miter saw manual 36-220

Show quick links. Hide Hide permanently.

Delta miter saw manual 36-220

Delta 12" single-bevel compound miter saw instruction's manual 18 pages. Saw Delta Instruction Manual 12" dual-bevel compound miter saw 23 pages. For Parts, Service, Warranty or other Assistance, Page 2: Safety Rules If you have any questions rela- tive to a particular application, DO NOT use the machine until you have first contacted Delta to determine if it can or should be performed on the product.

NEVER reach around saw blade.

Delta miter saw manual 36-220

DO As a result, this saw is equipped with a two-prong plug which permits you to use any conventional Volt electrical outlet without concern for main- taining a ground connection. Push down on the cuttinghead handle slightly and rotate latch A Fig.

Decide on which side of the saw table you want the stock stop A Fig. NOTE: The most commonly used position of the stock stop will be on the right hand table extension, as shown.

Types of signal transduction pathways pdf download

The work clamp A Fig. Insert post of work clamp into the hole located on the front of the saw base, as shown.

Simply loosen lock handle A Fig. Then tighten lock handle A. This can be accomplished by lowering the cutting arm A Fig.

Delta miter saw manual 36-220

Loosen bevel lock handle and tilt the cutting arm all the way to the right and tighten the bevel lock handle. Using a square A Fig.

Delta 36-220 Instruction Manual

NOTE: This adjustment should be checked with the cutting arm moved all the way to the right blade 90 degrees to the table. Lower the cutting arm.

Delta miter saw manual 36-220

The saw blade A Fig. Page 14 7. Loosen the two fence locking screws, one of which is shown at A Fig. Then tighten the two fence locking screws A.

Using a square, place one end of the square against the blade and the other end against the table and check to see if the fence is 90 degrees to the blade. The downward travel of the saw blade can be limited to prevent the saw blade from contacting any metal sur- faces of the machine. This adjustment is made by loos- ening locknut A Fig. Page Cutting Crown Moulding 9.

Bernard lewis islam and the west pdf printer

Page Auxiliary Wood Fence Fig. NOTE: A triangle indicator is provided on the miter scale to find this angle quickly. NOTE: A triangle indicator is provided on the bevel scale to find this angle quickly.

Shop with confidence

Brush life varies. It depends on the load on the motor. Check the brushes after the first 50 hours of use for a new machine or after a new set of brushes has been installed. Page Work Clamp Two Year Limited Warranty Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which in normal use has proven to be defective in workmanship or material, provided that the customer returns the product pre- paid to a Delta factory service center or authorized service station with proof of purchase of the product within two years and provides Delta with reasonable opportunity to verify the alleged defect by inspection.

Delta miter saw manual 36-220

Comments to this Manuals Your Name:. Enter text from picture:.

Delta 36-220 Type 3 Miter Saw Parts

The picture of my saw is different than the one you have for Delta model type three. MFG date I want to change the blade and it's different from your picture. Print page 1 Print document 24 pages. Cancel Delete.

Sign in OR. Don't have an account? Sign up! Restore password.