Genie GS-2632 Operators Manual With Maintenance Information
AirLiquide - Anaesthetic Gas Suction System
Genie scissor lift operator's manual with maintenance information ce models 34 pages. Page 2: Table Of Contents Only trained and authorized personnel shall be permitted to operate this machine.
This manual should be considered a permanent part of your machine and should remain with the machine at all times. If you have any questions, call Genie Industries. Contents Page Safety Rules Page 3: Safety Rules You read, understand and obey employer's safety rules and worksite regulations. You read, understand and obey all applicable governmental regulations.
You are properly trained to safely operate the machine. Part No.
Aeonmed Aeon 7400
Page 4 KV to KV 6. Platform retracted lbs kg Use extreme care and slow speeds while driving Page 6 Do not operate the machine with the chassis trays Do not replace items critical to machine stability open. Do not place or attach fixed or overhanging loads to any part of this machine. Page 7 Observe and use the color-coded direction arrows on the platform controls and platform decal plate for drive and steer functions.
No stunt driving or horseplay while operating a machine. Page 8 Be sure all decals are in place and legible.
Page 9 Bodily Injury Hazard Decal Legend Do not operate the machine with a hydraulic oil or Genie product decals use symbols, color coding air leak. Page 10 The battery tray should remain open during the entire charging cycle. Do not contact the battery terminals or the cable clamps with tools that may cause sparks.
Page Pre-operation Inspection Scheduled maintenance inspections shall be performed by qualified service technicians, according to the manufacturer's specifications and the requirements listed in the responsibilities manual. Page Maintenance Indicates that tools will be required to perform this procedure. Indicates that new parts will be required to perform this procedure.
Page 17 4 Remove the battery vent caps. If needed, replenish with distilled water to the bottom of the battery fill tube. Do not overfill. Page Function Tests 3 Always perform function tests prior to use. Know and understand the function tests before going on to the next section.
Page 19 8 Activate the up function. Result: The platform should raise. Result: The platform should lower. The descent alarm should sound while the platform is lowering. Page 20 22 Press and hold the function enable switch. Slowly move the control handle in the direction indicated by the yellow arrow.
Page 21 Result: The drive function should not work in either direction. Note: The brakes must be able to hold the machine on any slope it is able to climb.
Page 22 Raise the platform. Page Workplace Inspection 5 Only use the machine as it was intended. Page Operating Instructions That means every new operator should perform a pre-operation 4 Inspect the workplace.
Fabius gs operators manual container
Page 25 Machine travel speed is restricted when the platform is raised. Battery condition will affect machine performance. Machine drive speed and function speed will drop when battery level indicator is flashing. Page 26 To determine the slope grade: Measure the slope with a digital inclinometer OR use the following procedure. Page 27 3 Lower the platform until the safety arm rests when using the controller. Keep clear of the safety Battery Level Indicator arm when lowering the platform.
Full Use the LED diagnostic readout to determine the battery level. Charging Instructions Use only Genie authorized battery and charger.
If the machine must be towed, secured before releasing the brakes. Page 30 2. Adjust the rigging to prevent damage to the machine and to keep the machine level.
Page 31 Inspect the entire machine for loose or unsecured items. Use chains or straps of ample load capacity.
Use a minimum of 2 chains or straps. Adjust the rigging to prevent damage to the chains.
Page Specifications It should be used only with adequate safety factors. Platform extension length 39 in 99 cm Continuous improvement of our products is a Genie policy. Product specifications are subject to change without notice or obligation.
Continuous improvement of our products is a Genie policy. Comments to this Manuals Your Name:. Enter text from picture:. Latest comments:. Print page 1 Print document 37 pages.
Genie GS-1530 Operator's Manual
Cancel Delete. Sign in OR. Don't have an account? Sign up!
Dräger Fabius GS premium - Daily checkout procedure