Goodman does not. The material in this manual does not supercede manufacturers. All rights reserved.
Chapters Table Of Contents 2 Servicing Compatible, multi-position, modulating variable-speed gas furnace 12 pages. Goodman does not assume any responsibility for property damage or personal injury due to improper service procedures or services performed by an unqualified person.
The material in this manual does not supercede manufacturers installation and operation instructions. Page 3 To locate an authorized servicer, please consult your telephone book or the dealer from whom you purchased this product. Lisez d'abord les consignes de securite ci-dessus.
Reglez le thermostat a son point le plus bas. Page 7: Product Identification Stainless Steel tubular heat exchanger. Page 8 3 minute timed off delay when the compressor goes off. Disconnect all power to the furnace.
Do not touch the integrated control module or any wire connected to the This is a Category lV furnace. Two permanent open- Chimney or Gas Vent ings, one commencing within 12 in.
Leveling Leveling ensures proper condensate drainage from the heat R exchanger and induced draft blower.
For proper flue pipe drainage, the furnace must be level lengthwise from end to end. Do NOT terminate over public walkways.
Manualslib has more than 2277 Goodman manuals
The fuse or sories. Use two side returns or one side return and one bottom 9. Operate furnace with burners firing for approximately ten To determine proper air movement, proceed as follows: minutes. Check BTU input to furnace - do not exceed 1. With clean filters in the furnace, use a draft gauge in- input rating stamped on rating plate.
The control board can be reset by cycling volt power to the furnace. The only time resizing is required is when a reduction in firing rate is required for an increase in altitude or a furnace Two stage gas valves always require 24 volts between com- is being converted for use with LP gas. Turn OFF gas to furnace at the manual shutoff valve and disconnect manometer. Reinstall plug before turning on gas to furnace.
Adjust Vent 7. Measure the gas manifold pressure with burners fir- ing. Adjust manifold pressure using the Manifold Gas Pressure table shown below.
Replace the outlet pressure boss plug 8. Page High Altitude Application usa 4 seconds. Check for volts from Line 1 Hot to Line 2 Neutral supplier to determine the proper orifice size.
Flame current can be measured in two ways: R R R The drain tubes, standpipe, and field supplied drain line must 4.
Inclined Manometer - to measure static pressure, be checked annually and cleaned as often as necessary to pressure drop across coils, filters, and draft. This manual is also suitable for: Amec Comments to this Manuals Your Name:.
Enter text from picture:. Latest comments:.
Print page 1 Print document 58 pages. Cancel Delete.
Sign in OR. Don't have an account? Sign up! Restore password.